Push-Lok Hose Mender

Push-Lok Hose Mender
Order Now: call sales at 1-800-541-6351 7-5 PST M-F, 8-Noon Saturday or sales@spokanehose.com any time
Or, use the quote form below to send a quote request.
Push-Lok Hose Mender
Hose Ends Series: 100 B Series Typical Application: Low pressure shop or service air lines. Often used for low pressure lube and oil lines. Compatible Hose: Pushlok Pressure: Determined by maximum working pressure for hose size. Material: CA360 brass Advantages: Easy to assemble - just push the fitting onto the hose. No clamps needed! Low cost and a wide selection of configurations and sizes. Assembly Instructions: 1.Lubricate insert. 2.Hold hose at angle as shown and push on and up over first barb. 3.Continue to push straight on until hose is seated under protective plastic cap. (Keep hand back from hose end area so that hose can expand.) Disassembly Instructions: 1.Split hose as shown. Do not cut completely through hose. Sealing edge of barb could be damaged. 2.Bend hose and remove with quick pull. Note: Configurations and dimensions subject to change without notice.
Manufactured by Various
Product Group Data
Part No.Hose I.D.
1/4
5/16
3/8
1/2
5/8
3/4

View Current Quote